Majority of youtuber tech guys inserted bios chip like followingīut the software which I downloaded from this guide, display the insertion of the chip like following software version 1.30
I watched many tutorial videos in youtube and I confused about the insertion of the bios chip Recently I bought CH341A bios programmer for my 8 pin bios chip from asrock motherboard and I asked you here to clarify some procedures and software setup. Make sure it opens properly and looks correct in any BIOS editing tools you are familiar with too, then you'll know it's OK.Ĭonfusion about usage of the CH341A bios programmer If they're always good files and match then probably OK. Then repeat that a time or two and compare those two verified files, Open that file in hex editor and make sure it's not all FF"s. Verify after reading it should tell you chip and buffer or memory match, then that is possibly a good verified file (not always). If it verified good, then you hit save BIOS. Once you've done that, hit read and when it's done hit verify. Or different than ID too, like BIOS ends in FV sometimes BV works better, but you'll figure that out later if it comes to that. Sometimes you might need to choose less than full ID, Hit detect and if it detects your chip by ID OK, then select that one. Then open software of your choosing to try first, I already try newest version first.
Until you get verified and valid backup). If it is all FF's, that's verified invalid blank and you need to use another software version or CHIP ID and try again Run read, then verify, once it says "Chip/Buffer match" then that is verified, click save and then open that file in hex editorĪnd make sure it's valid BIOS and not all FF's. The contents of the files is not the same but it is very similar. You can compare the backup file with the original bios file from manufacturer site, using one hex editor software. Now press "Verify" and wait until the process is finished:Īttention, before continuing with the PART 3, please check the content of the backup file. Press "Read button" and wait until the process is finished: Go to "Auto" and uncheck "Erase" and "Blank check" options: Run CH341A_c.exe from CH341A programm v1.29 folder. Remove CMOS battery from your motherboard. Unzip the downloaded pack and install the ch341a drivers (run CH341PAR.EXE) INSTALL DRIVER, READ, VERIFY, SAVE BACKUP:ĭownload the CH341A tools from URL in original posting (Thanks to Lost_N_BIOS) Old Phoenix 4.05 - Need guidance on modd. IS THIS WORTH THE TROUBLE? Sony VGN-SZ18.
Lenovo thinkpad p53 remove WWAN whitelis.
0 kommentar(er)
